UV board is noble and not expensive, it is worth owning
UV board is noble and not expensive, it is worth owning
UV board is a kind of surface treated and made of PVC polymer particles. The appearance is similar to natural famous stones, but it makes up for various shortcomings of natural famous stones. At the same time, the UV board does not contain formaldehyde, no radiation, and is more environmentally friendly and safe. . The thickness of a general UV board is 5mm.
Two, UV board characteristics
A: High surface smoothness: the mirror highlight effect is obvious.
B: The paint film is plump: the color is plump and attractive.
C: Environmental protection: It does not contain volatile substances such as benzene, and is cured by ultraviolet light to form a dense cured film to reduce the emission of substrate gas.
D: No fading: Compared with the traditional board, the UV decorative panel will not lose its color for a long time, which solves the phenomenon of chromatic aberration.
E: Scratch resistance: the higher the hardness, the brighter it is, and the curing at room temperature will not deform for a long time.
F: Acid and alkali resistance and corrosion resistance: UV panels can resist the corrosion of various acid and alkali disinfectants.
Three, identify the quality of the uv board is good and bad
1. Raw materials: The most important material is resin raw materials. These resin raw materials are mainly used to produce pvc board, which is the bottom part of uv board. The common one is gray, the thickness ranges from 4mm-18mm, and the conventional thickness is 4mm. This kind of pvc board is in contact with the wall and fixed on the wall, with certain strength, moisture-proof, fire-proof and other characteristics. Excellent resin materials are ideal materials for uv panels.
2. Look at the thickness: this is also the easiest place for the owner to distinguish!
UV board is divided into 3MM, 5MM, 9MM, 12MM, 15MM, 18MM! Generally, the base plates used by UV board manufacturers are 2.7MM and 4.7MM. UV board manufacturers do UV treatment on the base plate, and the thickness is exactly 3MM, 5MM. This is the national standard UV board.
3. Look at the brightness and flatness of the surface treatment of the UV board: the standard UV board has a specular highlight, and you can see the shadows in the UV board when facing the human face (except for the matte ones, of course)! And put the UV board at the bright light, and then look at the flatness of the UV board! A good UV board is generally very flat. It is normal to occasionally see needle-sized particles. The national standard UV board!